Pro-tek Clutch Protector is made from Acetal Plastic for strength and durability. Helps protect your Clutch Cover from nasty spills and tip overs. No modifications or cutting required. Comes complete with instructions for easy installation. Comes with all mounting hardware, normally retail for $90.95 and many other brands even more expensive at lesser quality!
The clutch slider is to be mounted to the swing arm pivot shaft. Remove the stock nut and replace with the aluminum nut supplied in this kit. It is recommended to use a non-permanent thread lock compound. Torque the nut to factory specifications. The slider is designed to fit into your frame by sliding the puck over the nut (make sure the aluminum bushing is inside the puck and correctly positioned), then, using a non-permanent thread lock, insert & tighten the 10mm bolt supplied in this kit.
Includes: (1) 10mm x 35mm bolt
(1) Aluminum nut
(1) Acetal puck
Fitment: Yamaha '99-'05 YZF-R6, '06-'09 YZF-R6S & '98-'06 YZF-R1
*DOES NOT FIT ANY YZF600R Thundercats, only R6 and R6S from the years listed.
*This is a CLUTCH PROTECTOR not a frame slider set, it is only ONE PIECE to protect the Clutch on the right side of the bike ONLY!
